EPS-500C standby power supply is a high-end fashion power supply product of our company, which adopts aluminum alloy shell material, light portable, stylish and generous appearance, the core adopts power lithium battery, advanced manufacturing technology, abundant power output energy. Provide AC output, DC output two different voltage mode output, to meet the user's electronic products charging, AC power, and other aspects of electricity demand. This product can be used not only as EPS power supply, but also as outdoor emergency standby power supply.
This product has built-in power lithium battery with a total capacity of 555wh 150000 mAh to provide continuous power supply, as an indoor and outdoor standby emergency power supply, but also has a wide range of uses. 220V / AC / DC output, suitable for a variety of different equipment, Aerial drone, portable ventilator, medical equipment, mobile phone, tablet, notebook computer, desktop computer, small printer, all kinds of lamps, small fish tank, photography equipment, electric balanced unicycle charging, etc. It is very convenient for users to travel from home, outdoor homework, camping picnic, mountaineering adventure and so on.
Output power:Rated 500W Peak 750W
Iput voltage: AC ：85V-265V 50/60Hz
Output voltage: 220V 50Hz or 110V 60Hz （Optional)
DC output: 12V/4A：4pcs ， USB5V/2A：2pcs, USB5V/1A：2pcs
LED lamp: 1W Maximum 3W
Solar charging: 18V ≤60W以（Higher than 60W may burn out the protected IC）
Car charging: 12V/6A input ，do not use 24V .No controller
Output waveform: pure sine wave
Blackout reaction time: 5-10ms
Overload: Ac output disconnected after overload, indicator light bright red，disconnect load, restart recovery
Short circuit: Ac output disconnected after short circuit，disconnect load, restart recovery
lithium battery: Cycle life more than 500 times
Weight: N.W:7.0kg G.W: 7.5kg
1. The core adopts the power lithium battery and the advanced manufacturing assembly process to ensure the product quality is stable.
2. Use charger built-in mode, greatly improve product portability and practicability.
a ）It has the function of online switching.
b ）The shell uses aluminum alloy material, appearance fashion generous.
Function Introduction and instructions for use
Front panel description
When using the DC output function, turn on the corresponding DC switch, where DC 12 V and 5 V output can be used. When not in use, turn off the switch so as not to cause the power supply to consume its own power. The LED display screen shows the remaining power supply, 0-100%. When the electricity is insufficient, please charge the product in time for continued use. When using LED lights, turn on the corresponding switch.
Rear panel description
As shown in the picture,when in use, insert the AC input power cord into the AC socket and the other end into the AC input interface Then the load power cord is connected to the AC universal master of the product itself, and the AC output switch can be turned on and used normally. When there is no power outage, the AC power supply is used to supply the load. At the same time, the charging indicator light shows red when charging, and automatically switches to the internal battery of the product to supply the load when there is a sudden power outage.
Please note that the normal use of the access load is less than 500W, the load operating power should not exceed the output power of the machine itself. The output power is 750W and lasts for a few seconds. If the running power of the load exceeds 750W, the power supply can not be outputted when it enters the protection state. Remove the excess load, restart the power supply can be used normally. When the super power is used, it will cause the fuse of the machine to fuse.
When you take it out for outdoor use, turn off the switches and turn them on when you need to use them, otherwise it will cause automatic battery consumption.
Solar energy and car charging instructions: The solar energy interface is shown in the picture, the solar panel specification is 18V, less than 60W (solar controller may be burned when it is greater than 60W). When connecting to the solar panel, pay attention to the positive and negative electrodes can not be reversed, should correspond to the positive and negative electrodes of the interface (positive and negative inside and outside), otherwise can not be charged. When the solar panel is charged normally, the charging indicator is red. The input voltage of the cigarette lighter should be 12 V ≤ 6 A. do not use 24 V to charge this power supply.
Online switching usage
In the case of normal electricity, from the power supply to the equipment, at the same time charge the product.
During a sudden power outage, the internal lithium battery automatically switches the cost of the product to power the equipment.
In the face of sudden power outages, computers and so on can not be shut down to continue to work!
Product usage time comparison table
5V mobile phone
12V 3W LED light
About 170 times
About 6 hours
13 inches notebook PC
32 inches LCD TV
About 8 hours
Usage time (for reference only)
UPS Power mainframe
AC power cord
Manual and warranty card
Solar panel 18V 60W（Optional）
1. This product contains lithium battery, please stay away from the source of fire, if you do not use please do special treatment, do not arbitrarily discard.
2. Do not use this product in a humid environment or in water.Pay attention to moisture protection and use it in a ventilated and dry environment.
3. When using the product, please take it lightly, do not drop, beat or disassemble by force.
4. It is found that there are abnormal phenomena such as smoke or fire in the use of the machine, please stop using immediately and take relevant fire extinguishing measures.
5. When using this product, please turn it on first.Turn on the corresponding switch，If the LED indicator is on, confirm that there is output, and then use.
6. When using this product for the first time, please refer to the instruction manual.
7. When this product is unused, please take it out every three months or so to ensure the battery life. （It is the best to replenish about 50% of the electricity.）